Table of Contents
Advertisement
Additional MPLS Module Support Topics
•
show iproute {priority | vlan <vlan> | permanent | <ipaddress>
<netmask> | route-map | origin [direct | static | blackhole | rip |
bootp | icmp | ospf-intra | ospf-inter | ospf-as-external |
ospf-extern1 | ospf-extern2]} {sorted}
show ipconfig Command
The output of the
show ipconfig
enable/disable status of the specified VLAN(s).
show iproute and rtlookup Commands
The output of the
show iproute
include information about MPLS LSPs associated with the routes. The flags field
displayed by these commands has been enhanced to indicate the presence of MPLS next
hops. An uppercase
L
lowercase
indicates the presence of an indirect LSP next hope for the route.
l
show iproute
Optional
An optional
keyword has been added to the
mpls
commands. When the
some of the information normally displayed is omitted, and the LSP endpoint and
outgoing MPLS label are displayed instead. The LSP endpoint is the IP address/prefix
of the FEC associated with the LSP. The LSP endpoint matches the destination for direct
LSPs and is a 32-bit prefix address of a proxy router for indirect LSPs.
The
keyword only applies to some of the options available on the
mpls
command. The
s keyword is ignored when specified in conjunction with the
mpl
following options:
•
priority
•
route-map
•
summary
The modified syntax of the
rtlookup [<ipaddress> | <hostname>] {mpls}
9-6
command has been enhanced to indicate the
and
rtlookup
indicates the presence of a direct LSP next hop for the route. A
Keywords
keyword is specified, the information displayed is modified;
mpls
command is as follows:
rtlookup
commands has been enhanced to
and
show iproute
rtlookup
show iproute
MPLS Module Installation and User Guide
Advertisement
Table of Contents
