Extreme Networks BlackDiamond 6800 MPLS Installation And User Manual page 66

Configuring the Label Distribution Protocol
Table 4-1: LDP Configuration Commands
Command
config mpls [ldp | targeted-ldp] [hello |
keep-alive] <hold_time> <interval_time>
config mpls add vlan [<name> | all] {ldp}
config mpls delete vlan [<name> | all] {ldp}
4-4
Description
Configures LDP session timers. Specify one of
the following:
ldp — Specifies an LDP session.
I
targeted-ldp — Specifies a targeted LDP
I
session.
hello <hold_time> <interval_time> —
I
The amount of time (in seconds) that a hello
message received from a neighboring LSR
remains valid. If a hello message is not
received from a particular neighboring LSR
within the specified hello <hold_time>,
the hello-adjacency is not maintained with that
neighboring LSR. The range is 6 to 65,534.
The default setting for ldp hello
<hold_time> is 15. The default setting for
targeted-ldp hello <hold_time> is
45. The default setting for ldp hello
<interval_time> is 5. The default setting
for targeted-ldp hello
<interval_time> is 15.
keep-alive <hold_time>
I
<interval_time> — The time (in seconds)
during which an LDP message must be
received for the LDP session with a particular
peer LSR to be maintained. If an LDP PDU is
not received within the specified session
keep-alive <interval_time>, the
corresponding LDP session is torn down.The
range is 6 to 65,534. The default setting for
ldp keep-alive <hold_time> is 40. The
default setting for targeted-ldp
keep-alive <hold_time> is 60. The
default setting for ldp keep-alive
<interval_time> is 13. The default setting
for targeted-ldp keep-alive
<interval_time> is 20.
Enables LDP for one or all VLANs. If not
specified, LDP is enabled on the specified VLAN.
Disables LDP on one or all VLANs. If not
specified, LDP is disabled on the specified VLAN.
MPLS Module Installation and User Guide