Extreme Networks BlackDiamond 6800 MPLS Installation And User Manual page 95

A profile is a set of attributes that are applied to the LSP when the LSP is configured
using the
which cannot be deleted, but can be applied to any configured LSP. The profile name
for the default profile is default. The default profile parameter values are initially set to
their respective default values. The maximum number of configurable profiles is 255
(one of which is reserved for the default profile).
The
bandwidth
positive integer bps value is valid. Optionally, you can append the characters, k for
kilobits, m for megabits, or g for gigabits, to the bps value to specify the unit of
measure. If the k, m, or g, character is omitted, the unit of measure is assumed to be
kilobits. The default bandwidth bps value is zero, which indicates that the QoS for the
LSP is best effort. ExtremeWare does not support bandwidth reservation.
The
setup-priority
priority. During path set up, if the requested bandwidth cannot be reserved through the
LSR, the
setup-priority
LSPs to determine if any of the existing LSPs need to be preempted to allow a higher
priority LSP to be established. Lower numerical values represent higher priorities. The
setup-priority
also 0 to 7 and is set equal to the
support LSP preemption.
The
retry-timeout
allows for LSP setup. If the LSP cannot be established within
the LSP is resignaled. The default value for
configurable range of 5 to 600 seconds. The
LSRs the path can traverse, including the ingress and egress router. The default
hop-count
After an LSP has established, the egress LSR may be optionally pinged to determine
end-to-end path connectivity. If a ping response is not received within [2 *
ping-interface
keyword specifies how frequently an ICMP echo request is transmitted to the egress
LSR IP address on the established LSP. The default
indicates no end-to-end LSP health checking is performed. You can set the
ping-interval
The route
used to send data. Whenever the configured metric is less than, or equal, to the
calculated IGP metric, the LSP is used for sending routed IP traffic. In this case, the LSP
is also used to send TLS data when the TLS tunnel is configured by specifying the
tunnel LSP endpoint IP address. Traffic is distributed across up to four equal-cost LSPs.
MPLS Module Installation and User Guide
config mpls rsvp-te add lsp
parameter specifies the desired reserved bandwidth for the LSP. Any
and
hold-priority
parameter is compared to the
range is 0 to 7 and the default value is 7. The
keyword specifies the maximum number of seconds the switch
value is 255 with a configurable range of two to 255.
– 1] seconds, the LSP is considered unavailable. The
value to any interval between 0 and 60 seconds.
is used to determine if an established RSVP-TE LSP will actually be
metric
command. A default profile is provided
are optional parameters indicating the LSP
by default. ExtremeWare does not
setup-priority
retry-timeout
hop-count
ping-interval
Configuring RSVP-TE
of existing
hold-priority
hold-priority
retry-timeout
is 30 seconds with a
parameter limits the number of
ping-interval
is zero, which
range is
seconds,
5-21