Table of Contents
Advertisement
Additional MPLS Module Support Topics
Table 9-1: Changes to General Switch Commands (continued)
Command
unconfig switch {all}
Image and Configuration Attributes
Except as described below, the MPLS module supports all of the ExtremeWare
commands associated with managing image and configuration attributes. See the
"Software Upgrade and Boot Options" appendix in the ExtremeWare Software User Guide
for more information. Table 9-2 describes the command changes to support the MPLS
module.
Table 9-2: Changes to Image Commands
Command
download image [<ipaddress> |
<hostname>] <filename> {primary
| secondary} {slot <slot>}
use image [primary | secondary]
{slot <slot>}
802.1p and 802.1Q Commands
The MPLS module supports the
and 802.1Q commands are not directly applicable to the MPLS module.
9-4
Description of Change
This command clears any previously configured MPLS
module information
Description of Change
The slot <slot> option is added to this command to
support downloading of images to a specified MPLS module.
When you enter the command with this option, the image is
downloaded to the module in the specified slot rather than to
one of the image partitions on the switch.
The slot <slot> option is added to this command to
select which image will load on the module in the specified
slot on the next reboot.
config dot1q ethertype
command. Other 802.1p
MPLS Module Installation and User Guide
Advertisement
Table of Contents
