Extreme Networks BlackDiamond 6800 MPLS Installation And User Manual page 103

The following commands configure two RSVP-TE LSPs; one is the primary and the
other is a secondary or backup LSP. Each LSP uses the same profile but different paths.
config mpls rsvp add lsp Glasgow-Birmingham-lsp path
Glasgow-Birmingham-pri-path Glasgow-Birmingham-pro primary
config mpls rsvp lsp Glasgow-Birmingham-lsp add path
Glasgow-Birmingham-sec-path Glasgow-Birmingham-pro secondary
The secondary LSP is signaled, however it remains in a standby state unless the
primary path becomes unavailable.
By default, a TLS tunnel flows over any available LSP. However, a TLS tunnel can be
specifically directed to use a configured RSVP-TE based LSP. Configuration is no
different from configuring an LDP-based TLS tunnel, except that the RSVP-TE LSP is
explicitly specified. The following command specifically directs the TLS tunnel to use a
previously configured RSVP-TE:
config mpls add tls-tunnel Glasgow-Birmingham-cust1 lsp
Glasgow-Birmingham-lsp oxford-university vcid 50 from 2.0.0.0
MPLS Module Installation and User Guide
Configuration Example
5-29