Attaching And Detaching Incremental Encoder Input Signal Cables; 11. Lan Signal Cable "Lan - Toshiba TS3000 Series Instruction Manual

c. The CONV connector is a solder cap type connector that is joined by soldering
the wires. For details about the procedure for joining the wires to the connector
and applying the shielding, see the Appendix in Chapter 15.
10.2

Attaching and Detaching Incremental Encoder Input Signal Cables

For the procedure for attaching and detaching incremental encoder input signal
cables, see Para 4.11.

11. LAN Signal Cable "LAN"

The standard TS3100 has a one-channel LAN port.
In this function, TCP/IP protocol can be used to enable communication on the same
local area network with computers and visual equipment on the Ethernet. This allows
program creation and editing, debugging start support, and maintenance using the
computer programmer TSPC.
If a hub is used to connect to external equipment, connect using a straight cable.
Use a cross cable when connecting a computer directly to controller. Some
equipment has an automatic recognition function so that either a straight cable or
cross cable can be used, and so check the specifications of the equipment that is
used.
For details on the LAN communication function, see the Communication Manual.
Communication specifications
a. Interface:
b. Communication system:
c. Communication speed:
d. Maximum packet size:
e. Number of simultaneous connectable ports: 4
f. Internal connector (X8GC): RJ-45 (shielded)
g. Appliations:
10BASE-T
TCP
10 Mbps
512 bits/packet
IP0 Simple protocol communication (host computer)
IP1/IP2 Non-protocol communication (external equipment)
IP3 Exclusive communication (dedicated equipment)
– 112 –
INTERFACE MANUAL
STE 80729