Table of Contents
Advertisement
Chapter 2: INSTALLING THE CSMIM-T1
To set the Subnet jumper, refer to Figure 2-1 and configure pin row A of
J12 as follows:
•
Normal Operation (maintain continuity of the backplane: Default):
Place a jumper over the center pin and pin 3 in pin row A.
•
Subnet mode:
2.3
NETWORK BYPASS JUMPER
The CSMIM-T1 has an internal jumper that is used to select a bypass
mode for the T-1 Engine. The T-1 engine will go into a bypass mode when
the MMAC hub is powered down, reset, or when the CSMIM-T1 module
is removed from the hub. This jumper is labelled J24, and is located on the
modem board, just behind the T-1 Network Interface port (See Figure
2-2).
The jumper can be set to Network Loopback Mode (default setting) or
Bypass Mode. Please check your module to see that the jumper is
configured in the default setting before installing into your hub.
Network Loopback Mode loops back all signals on each interface.
The Bypass Mode will connect the DSX1 lines directly to the DS1 lines.
2-4
Place a jumper over the center pin and pin 1 in pin row A.
Front of Module
Top
Figure 2-2 Network Bypass Jumper
CSMIM-T1 Hardware Installation Guide
Loopback Mode: Jumper
over pins 2 and 3
J24
Bypass Mode: Jumper
over pins 1 and 2
1 2 3
1 2 3
Advertisement
Table of Contents
