Cabletron Systems CSMIM-T1 Installation Manual page 169

S4= n
Line Feed Character
Range: 0 - 127, ASCII decimal
Default: 10 (line feed)
Sets the character recognized as a line feed. The line feed
character follows the carriage return at the end of command
lines and result codes.
The modem does not store this register with &W; enter *W to save it.
S5= n Backspace Character
Range: 0 - 32, ASCII decimal
Default: 8 (backspace)
Sets the character recognized as a backspace.
The modem does not store this register with &W; enter *W to save it.
S6= n Wait Before Dialing
Range: 2 - 255 seconds
Default: 2 seconds
Sets the length pause after off hook before the modem dials. The
modem always pauses for a minimum of two seconds, even if
S6 is set less than 2.
Register S6 is valid only when either X0, X1, or X3 is set.
NOTE
The modem does not store this register with &W; enter *W to
save it.
S7= n
Wait for Carrier After Dial
Range: 0 - 255 seconds
Default: 60 seconds
Sets the length of time that the modem waits for
• Carrier from remote modem before hanging up (originate or
answer mode).
• Ring back (originate mode only, and only if either X3 or X4 is
set).
• Dial tone when the "W" dial modifier is encountered in a dial
string.
CSMIM-T1 Hardware Installation Guide
Registers
7-43