Table of Contents
Advertisement
2.8.1
Invoking the Console Monitor
After the image boots, you can invoke a Console Monitor by pressing the
<Enter> key on the console. At the Console Monitor prompt, entering
or ? displays the available options:
help
•
(from the CSMIM-T1 to the host and reboots).
dump
•
or
(displays the available options).
help
?
•
(displays configuration information for the CSMIM-T1).
info
•
(displays the current front panel LED status).
leds
•
(exit the Console Monitor, e.g., quit the console).
quit
•
filename (reboots the CSMIM-T1).
reboot
•
(returns the CSMIM-T1 to the ROM Monitor).
rom
•
(displays syslog messages).
syslog
2.8.2
Self-Booting the CSMIM-T1
After you have installed your optional Flash ROM, the CSMIM-T1 can be
self-booted. You can check your CSMIM-T1 configuration by entering
the
command at the
config
displays the current configuration information and revision levels. If your
device has Flash ROM installed, the line "FLASH PROM size:" will
appear under the REVISION/CONFIGURATION INFORMATION
section.
This section contains a description of what you need to do to boot your
CSMIM-T1 from FLASH ROM. See Section 3.2 for more information on
the commands referenced here. Proceed as follows:
1.
Enter the ROM Monitor mode (see Section 2.4.1 for information on
entering the ROM Monitor mode).
2.
Set the Internet address to a valid IP address and the Subnet Mask to a
valid mask using the
3.
Using the
sequence
4.
Execute the
CSMIM-T1 Hardware Installation Guide
Monitor::
command.
addr
command, set the interface sequence to self.
command (expect this to take upward of 5 minutes).
boot
Software Installation Procedures
prompt. The
config
command
2-15
Advertisement
Table of Contents
