Cabletron Systems CSMIM-T1 Installation Manual page 176

Chapter 7: AT Commands and Registers
If you use register S23 to change the parity set automatically or
NOTE
set by -On, the same number of data and stop bits used before
the change is retained. For example, if 8 data bits and even
parity is set (-O6) and you change register S23 to odd parity,
the 8 data bits and 1 parity bit are retained. However, the parity
becomes odd instead of even, changing the Serial-Port Parity
command setting to -O5.
S25= n
Delay to DTR and Asynchronous Time Delay
Range: Delay to DTR: 0 - 255 hundredths of a second
Async mode: 0 - 255 seconds
Default: Delay to DTR: 5 hundredths of a second (0.05 seconds)
Async mode: 5 seconds and 0.05 seconds
Delay to DTR: During asynchronous mode with &M2 or &M3
set, the modem ignores an On-to-Off transition of DTR that is
less than the register S25 time delay.
Asynchronous time delay: Register S25 sets the number of
seconds the modem waits to check DTR after establishing a
connection. After this time delay, the Delay to DTR time delay
described above takes effect when loss of DTR occurs.
S27= n Bit Mapped Register (Table 7-13)
Table 7-13 Saved Command Settings with S27
Bit
Function
Position
6 answer tone when at 1200
bps
7 not used
T0= n
Timer for V.22bis, V.22, and V.32 Modes During
:
Multi-Protocol Answer
Where n is an integer from 0 to 255, in tenths of a second.
Default is 40 (4 seconds).
7-50
Decimal Value
0 ITU-T V.22bis/V.22
1 Bell 212A when supported
CSMIM-T1 Hardware Installation Guide