Chapter 2 Setup And Installation; Installing The Wpim-S/T Into A Host; Jumper Settings - Cabletron Systems WPIM-S/T User Manual

2.1

INSTALLING THE WPIM-S/T INTO A HOST

To physically install the WPIM-S/T into the host platform, please refer to
the Cabletron Systems WPIM Setup Guide enclosed in the shipping box
with the WPIM-S/T.
2.2

JUMPER SETTINGS

The WPIM-S/T has two jumpers (P1 and P2) for the 100 ohm ISDN Bus
termination. See
device and must be set the same way to take care of both the transmit and
receive pair of the twisted pair cable. The WPIM-S/T is shipped with the
jumpers at a default setting of terminated.
WPIM-S/T User's Guide
CHAPTER 2
SETUP AND INSTALLATION
Figure 2-1. The jumpers must be set before using the
TR
P2
Figure 2-1 Termination Jumpers
J2
P1
TR
termination
2-1