Cabletron Systems CSMIM-T1 Installation Manual page 70

Chapter 4: CSMIM-T1 Parameters
stats -T
The stats -T command displays T-1 network interface statistics for the
Annex. Table 4-2
stats -T [ current | total | all |
Table 4-2 Arguments for the stats -T Command
Argument
current
total
all
interval _set
clear_alarm
The stats -T current command display looks like this:
annex# stats -T current
alarm history: [ no blue no red no yellow ], Fri July 28 16:48:37 1995 EDT
Alarms:
no yellow
engine:
no loss of signal
serial number:
circuit ID:
T1 info:
unit ID: XYLOGICS T1-ENGINE 085234 Rev. A 07/19/95 6343
loopback mode: No loopback
number of valid seconds:
bursty errored seconds (ESF only):0
errored seconds:
unavailable seconds:
out of frame errors:
CRC errors (ESF only):
received net alarms:
annex#
4-2
describes the arguments for stats -T. The syntax is:
interval_set | clear_alarm ]
Displays Extended Super Frame (ESF) statistics for the
current fifteen minute interval. The tni_framing parameter
must be set to esf (default). If the tni_framing parameter is
set to d4 , the current statistics are not displayed.
Displays the total number of ESF statistics collected.
Displays all ESF statistics.
Displays a specific ESF interval. You can enter a single
interval or a range of intervals from 1 to 96. Interval 1 is the
most recent interval.
Clears the alarm condition saved in the history buffer.
offline
08
CSMIM-T1 Hardware Installation Guide
Description
no blue
no sync
uptime: 69:07:49
Current Statistics
469
Controlled slip seconds:0
0 Severly errored seconds:0
0
0 bipolar violations:
0 controlled slilps:
0
no red
no D&I sync
0
0