Cabletron Systems CSMIM-T1 Installation Manual page 145

In reliable link connect state, the sender's Break control setting
NOTE
determines how the receiver handles the Break.
Table 7-2 illustrates the \Kn command
Local DTE sends
Break during reli-
able or normal
connection
Enter command
state; no Break to
\K0
remote system*
Empty data buff-
\K1
ers; send Break to
remote system
Same as \K0*
\K2
Immediately send
\K3
Break to remote
system
Same as \K0*
\K4
Send Break to
remote system in
\K5
sequence with
transmit data
*Forces the modem to command state. To transmit a Break and enter connect
state, type: AT\BO <Enter>.
CSMIM-T1 Hardware Installation Guide
Table 7-2 The \K n Command
Local DTE sends
\B n ; local modem
in command
mode, during reli-
able or normal
connection
Empty data buff-
ers; send Break to
remote system
Same as \K0
Immediately send
Break to remote
system
Same as \K2
Send Break to
remote system in
sequence with
any transmit data
being buffered
Same as \K4
Local modem
sends Break
during direct
connection
Send Break to
remote system;
set modem to
command state
Send Break to
remote system
Same as \K0
Same as \K1
Same as \K0
Same as \K1
Commands
Remote
modem sends
Break during
normal connec-
tion
Empty data buff-
ers; send Break
to serial port
Same as \K0
Immediately
send Break to
serial port
Same as \K2
Send Break to
serial port in
sequence with
receive data
being buffered
Same as \K4
7-19