Cabletron Systems CSMIM-T1 Installation Manual page 44

Chapter 3: ROM Monitor Commands
addr [-d]
boot [-v] [<file>]
boot [-l] [<file>]
config
console-baud
erase
help (or "?")
image [-d/<file>]
ipx [-d]
lat_key [-d]
mop [-d]
net
option_key [-d]
ping
ports [-d]
sequence
[-d | <list>]
slip [-d] <port>
stats [-slip]
3-2
Table 3-1 ROM Monitor Command
Displays and sets EEPROM values relevant to network
addressing, including the CSMIM-T1's Internet address.
Manually boots and loads the CSMIM-T1's operating
code.
Erases the existing Flash memory and copies a new
image to Flash.
Displays the current hardware configuration and
revision levels.
Changes the console port's baud rate.
Erases non-volatile memory.
Display the list of ROM Monitor commands.
Displays and/or sets the load image and TFTP load
dump names.
Sets IPX load/dump file server.
Sets LAT key.
Sets MOP load/dump address.
Executes an Ethernet stand-alone external loopback
test.
Sets or displays the option key.
Sends ICMP ECHO_REQUEST, host [data size]
[npackets].
Shows the current status of all ports and tests specified
port(s).
Displays and edits the load/dump interface list.
Configures an SLIP interface.
Displays current network statistics gathered by the
ROM.
CSMIM-T1 Hardware Installation Guide