Cabletron Systems CSMIM-T1 Installation Manual page 133

D <dial string> Dial
Where <dial string> is a string of up to 98 characters. Do not type
< or >.Valid dial string characters are: 0-9, dial modifiers, and for
tone dialing A, B, C, D, #, and*. The modem ignores invalid
characters. Dial strings longer than 98 characters produce an error
message.
Dials a telephone number and attempts to establish a connection.
The Dial command must be the last one on a command line.
To cancel the Dial command, press any key or use your data
communications software to lower DTR (unless &D0 is set).
To dial the telephone number 011 22 555 1234, type:
ATD 011225551234 <Enter>
After disconnect, there is a 5-second delay before the modem
NOTE
goes off hook in originate mode.
Dial Modifiers
Dial modifiers allow you to add conditions to the telephone
number you dial. You can use several modifiers with the same
telephone number. Dial modifiers include:
^A (Link Negotiation) Perform link negotiation at 4,800 bps for the
current connection only. (This dial modifier is equivalent to the
*H2 command.)
J (Link Negotiation) Perform link negotiation at 1,200 bps for the
current connection only. (This dial modifier is equivalent to the
*H1 command.)
K (Cell-Side Cellular Connection) Sets )M1 for the current
connection only.
P (Pulse Dial) Placed anywhere in the dial string, causes the modem
to pulse dial. For example: ATD P5551234 <Enter>.
CSMIM-T1 Hardware Installation Guide
Commands
7-7