Cabletron Systems CSMIM-T1 Installation Manual page 129

%A n
Auto-Reliable Fallback Character
Where n is an integer between 0 and 127 indicating an ASCII
character (Default is 0, auto-reliable fallback character disabled).
Sets the ASCII character recognized as the auto-reliable fallback
character on the answering modem. In auto-reliable mode, when
the modem encounters an incoming auto-reliable fallback
character from the remote system, it automatically switches to
normal mode and passes the character to the serial port.
Auto-reliable fallback character recognition stops if the modem
receives a SYN character (decimal 22).
Do not set n=63 or n=126. These settings interfere with V.42
!
negotiations.
CAUTION
With this command, \ N3 \ C2 must also be set.
NOTE
\A n
Maximum MNP Block Size
\A0 Sets block size up to a maximum of 64 characters.
\A1 Sets block size up to a maximum of 128 characters.
\A2 Sets block size up to a maximum of 192 characters.
\A3 Sets block size up to a maximum of 256 characters.
Sets maximum block size for MNP stream link connections.
B n
ITU-T/Bell Mode
B0 Uses ITU-T V.22 and V.21 standards at 1,200 and 300 bps.
B1 Uses Bell 212A and 103 standards at 1,200 and 300 bps.
B n Serial-Port Bps Rate
$
Where n = 75; 300; 600; 1,200; 2,400; 4,800; 9,600; 19,200;
38,400; 57,600; 115,200 bps.
Sets the serial-port bps rate when issued.
CSMIM-T1 Hardware Installation Guide
Commands
7-3