Table of Contents
Advertisement
1.6.2
System LED Indicators
There are 7 indicators to show system activity and status.
ATTN
The amber Attention LED is on when the module requires operator
attention, and flashes when a problem is detected.
STAT
The green Status LED is ON after the module passes the core power-up
diagnostics. This LED also flashes while the module is in a reset state.
TRAF
The green Traffic LED flashes when the module successfully transmits or
receives data over the MMAC Ethernet backplane channel.
S/U
When the green SET UP LED is ON steady, the module is in the SET UP
mode and the user can input configuration data via the console port prior
to booting the operational software.
When the module is in the RESET mode (press and hold the SET UP
button for 3 seconds) the green LED will flash while the CSMIM-T1
executes power up diagnostics.
Ethernet Channel Indicators
There are three green LEDs that indicate the Ethernet channel
(A, B, or C) that is selected by either the software or by jumper
configuration.
1.6.3
The SET UP Switch
The SET UP Switch allows the user to change the operational mode of the
module from normal to set up. When the module powers up, it
automatically enters the normal mode. To enter the SET UP mode, the
SET UP switch must be depressed within 30 seconds of power-up. When
the S/U LED lights, the unit is in the SET UP mode.
Depressing the SET UP Switch at any time for approximately three
seconds causes the module to enter a RESET state. This is the equivalent
of a reboot. The green S/U LED will flash while the unit executes power
up diagnostics, and the SET UP mode can be entered.
CSMIM-T1 Hardware Installation Guide
CSMIM-T1 Front Panel
1-7
Advertisement
Table of Contents
