Table of Contents
Advertisement
Chapter 5: Troubleshooting Procedures
Activity T2: Testing the Hardware
During power-up, the CSMIM-T1 runs self-tests that execute diagnostics
for the CPU, ROM, EEPROM, FLASH, etc. The TRAF indicator flashes
during the tests and after completing the power-up self-tests, the STAT
and Ethernet channel indicators remain on.
Activity T3: At the Monitor Prompt
When the STAT and ATTN indicators are on, the ROM monitor prompt
displays on the console terminal. Enter the boot command at the prompt.
If you do not enter a filename with the command, you are prompted to do
so.
5.2.2.2
SETUP Mode Error States
Table 5-5
contains a description of the indicators that are used to describe
errors that occur at different stages of the system start-up process. If the
CSMIM-T1 fails while testing the hardware, (state T2), the error
condition is hardware failure TE2. A description of each error condition
follows
Table
5-5.
Activity
TE2: Hardware Failure
TE7: Booted Wrong Image
Key:
On continuously.
Off.
Flashing irregularly.
Flashing regularly (about 1Hz).
5-8
Table 5-5 Normal Mode Error LED States
STAT
ATTN
Green
Amber
CSMIM-T1 Hardware Installation Guide
TRAF
Green
Advertisement
Table of Contents
