Console-Baud - Cabletron Systems CSMIM-T1 Installation Manual

Chapter 3: ROM Monitor Commands
3.2.4

console-baud

The console-baud command changes the console port's baud rate. Thus,
the console port can interface with any modem to which it is connected.
When the baud rate is entered as auto, the CSMIM-T1 detects the baud
rate of the incoming line and adjusts its baud rate accordingly. This
command provides support for remote troubleshooting. The command
syntax is:
console-baud
The command display looks like this:
monitor:: console-baud
Remote Diagnostic Test Mode
In order to use the remote diagnostic functionality, you
must first connect a modem to the console port of the
Annex. The modem should be configured such that DTR is
forced on, carrier detect and DSR are set normal, and
auto-answer is enabled. Once this is done, contact your
service representative for remote diagnostic maintenance.
To enter "Autobaud Mode", please type "Auto". To
"manually" configure the Annex console port, please type
in the desired baud rate. To return to the "monitor::"
prompt strike the "carriage return <CR>" key.
[Baudrate Range: 50-9600 BAUD]
Select Baudrate []::
This command has no effect on the port's baud rate after the
NOTE
CSMIM-T1 is booted
To provide remote access to the CSMIM-T1 ROMs:
1. From a site local to the CSMIM-T1:
• Set the CSMIM-T1 into test mode so the monitor prompt appears
on the console.
• Set the modem into auto-answer mode.
3-12 CSMIM-T1 Hardware Installation Guide