Cabletron Systems CSMIM-T1 Installation Manual page 153

Table 7-7
operating mode. NC indicates No Connection. Where more than
one operating mode is in a column, the first mode is for the
originating modem and the second mode is for the answering
modem.
MNP Extended Services: In the chart, you can use MNP
NOTE
Extended Services for V.42 connections where LAPM appears
if both modems are set with -K1 or -K2.
Table 7-7 Connection Types Depending on Operating Mode
Answering
Originating Modem
Modem
\N0
\N0 normal
\N1 normal
/direct
\N2 NC
\N3 normal
\N4 NC
\N5 direct
\N6 NC
O n Enter Connect State
O0 Enters connect state.
O1 Begins an equalizer retrain sequence when operating at 2,400 bps
or higher and then returns to connect state.
Type: ATO1 <Enter> to reduce errors due to loss of equalization
when excessive bit error rates are present.
CSMIM-T1 Hardware Installation Guide
indicates the type of connections, depending on the
\N1 \N2
direct NC
/normal
direct NC
NC MNP
direct MNP
/normal
NC NC
direct NC
/normal
NC MNP
\N3 \N4
normal NC
normal NC
/direct
MNP NC
LAPM LAPM
LAPM LAPM
LAPM LAPM
LAPM LAPM
Commands
\N5 \N6
normal NC
normal NC
/direct
NC MNP
LAPM LAPM
LAPM LAPM
LAPM LAPM
LAPM LAPM
7-27