Cabletron Systems CSMIM-T1 Installation Manual page 36

Chapter 2: INSTALLING THE CSMIM-T1
At the monitor prompt on the console, type config and press the
Return key. The following appears on the screen:
ROM Software Rev: 0914
Board ID: 42
CPU Type: 486SXLC2
Memory size: 4 Meg
Flash size: N/A
T1 Unit Identification: XYLOGICS T1-ENGINE 085234 Rev. A 07/19/95 6343
T1 Network Jumper: Cross Connect Mode
DS0: B8ZS Coding
DSX: B8ZS Coding
Port # 1
T1 Slot Map N
Mod ID 288X
Mod Status OK
Port # 13
T1 Slot Map N
Mod ID 288X
Mod Status OK
To record the CSMIM-T1's Ethernet address for future reference: at the
monitor prompt, type addr -d and press the Return key. The display
looks like this:
monitor:: addr -d
Ethernet address (hex): 00-80-2D-00-18-B6
Internet address: <uninitialized>
Subnet mask: 255.0.0.0
Broadcast address: 0.0.0.0
Preferred load host address: <any host>
Preferred dump address: 0.0.0.0
Load/Dump Gateway address: <uninitialized>
Type of IP packet encapsulation: <ethernet>
Load broadcast: Y
You are prompted for the gateway address only if the Internet
NOTE
address differs from the preferred Load Host address based on
the Subnet Mask. If these addresses are the same, the
CSMIM-T1 assumes there is no gateway.
2-10
REVISION/CONFIGURATION INFORMATION
Board Type: CSMIM-T1
Ethernet Address: 00-80-2D-00-18-B6
EEPROM size: 65504
Flash ID: N/A
ESF Framing
ESF Framing
2 3 4
N N N
288X 288X 288X
OK OK OK
14 15 16
N N N
288X 288X 288X
OK OK OK
CSMIM-T1 Hardware Installation Guide
AT&T FDL Format
Line Distance=535 to 635 Feet
5 6 ..... 11
N N ..... N
288X 288X ..... 288X
OK OK ..... OK
17 18 ..... 23
N N ..... N
288X 288X ..... 288X
OK OK ..... OK
12
N
288X
OK
24
N
288X
OK