Cabletron Systems CSMIM-T1 Installation Manual page 74

Chapter 4: CSMIM-T1 Parameters
The reset internal_modem command resets the specified T-1
modem_set. There is no physical reset button. A modem reset forces the
port to be reset. In addition, if the signal protocol is set to wink start or
immediate start, a special AT command is sent to the modem to select the
dialtone detection mechanism.
The
modem_reset
separated by commas, or a range of numbers separated by a hyphen. The
valid modem number range is 1 to 24, inclusive.
Table 4-4 Keywords for the
Keyword
soft
hard
esf
4-6
parameter specifies the individual modem numbers,
This setting reconfigures the software parameters and will
only disrupt the service on the DS0 channels that are
changed.
This setting resets the T-1 engine causing the T-1 Drop/Insert
interface and modem sessions to terminate.
Note: If modem sessions and/or equipment are attached to
the Drop and Insert Interface, their service will be interrupted
for a short period of time (usually a few seconds).
This setting resets all the ESF counters in the T-1 engine.
CSMIM-T1 Hardware Installation Guide
reset t1
Command
Definition