Table of Contents
Advertisement
When the CSMIM-T1 boots in test mode, the console displays the load
server host's Internet address, and indicates whether it receives a response
to its Open File Request and to any of its Read File Requests. The host's
progress report indicates receipt of any File Server Requests and its
responses to such requests. The host displays erpc_return 0 if it
successfully receives a request and is sending out an affirmative response.
If any CSMIM-T1-related files are missing or cannot be installed, contact
technical support (see Getting Help section in Preface).
A PC host running the UNIX operating system has the erpcd daemon
(provided with the distribution and installed in /usr/annex) running in the
background on the PC. Set the CSMIM-T1 and the erpcd on the load host
into test mode:
1.
For erpcd on the load server host, as superuser, kill the erpcd program
and restart it using the –D option:
# /usr/annex/erpcd -D5
2.
On the CSMIM-T1, hold down the
enter the SET UP mode. Then enter:
monitor:: boot -v
5.3.2.3
Another CSMIM-T1
When troubleshooting a CSMIM-T1 configured as a load server host:
1.
Use the CLI telnet command to access the unit and verify that it is up
and running.
2.
Communicate with the unit on the Ethernet using the superuser CLI
ping command.
3.
Verify the unit's configuration using na.
The Annex Network Administrator's Guide provides more information on
these commands.
A CSMIM-T1 that has been reconfigured as a load server host, but not
rebooted, cannot boot another CSMIM-T1 on the network. Rebooting the
CSMIM-T1 load server host ensures that the parameters are set.
CSMIM-T1 Hardware Installation Guide
for 3 seconds to
SET UP button
BOOT Failures
5-15
Advertisement
Table of Contents
