Monitoring IP Parameters
The IA provides display of IP statistics and configurations contained in the routing table.
Information displayed provides routing and performance information.
To display IP information, enter the following commands in Enable mode:
Show ARP table entries.
Show IP interface configuration.
Show all TCP/UDP connections
and services.
Show configuration of IP interfaces.
Show IP routing table information.
Show ARP entries in routing table.
Show DNS parameters.
Configuration Examples
Assigning IP Interfaces
To enable routing on the IA, you must assign an IP interface to a VLAN. To assign an IP
interface named RED to the BLUE VLAN, enter the following command:
ia(config)# interface create ip RED address-netmask
10.50.0.1/255.255.0.0 vlan BLUE
You can also assign an IP interface directly to a physical port. For example, to assign IP
interface RED to physical port et.3.4, enter the following command:
ia(config)# interface create ip RED address-netmask
10.50.0.0/255.255.0.0 port et.3.4
Internet Appliance User Reference Manual
Chapter 4: IP Routing Configuration Guide
arp show all
interface show ip
ip show connections [no-lookup]
ip show interfaces [
ip show routes
ip show routes show-arps
system show dns
<interface-name>
]
61