Table of Contents
Advertisement
The next sections describe Lite, Standard, and Professional RMON groups and control
tables.
RMON Groups
The RMON MIB groups are defined in RFCs 1757 (RMON 1) and 2021 (RMON 2). On the
IA, you can configure one or more levels of RMON support for a set of ports. Each level—
Lite, Standard, or Professional—enables different sets of RMON groups (described later in
this section). You need to configure at least one level before you can enable RMON on the
IA.
To specify the support level for RMON groups, use the following CLI command line in
Configure mode:
Specifies Lite, Standard, or
Professional RMON groups.
To specify the ports on which RMON is to be enabled, use the following CLI command
line in Configure mode:
Specifies the ports on which
RMON is enabled.
You can configure each level of RMON support independently of each other with default
tables on or off. For example, you can configure Lite with default tables on for ports
et.1.(1-8) and then configure Standard with no default tables for the same ports. You
cannot configure Lite on one set of ports and Standard on another set of ports.
Internet Appliance User Reference Manual
Chapter 17: RMON Configuration Guide
rmon set lite|standard|professional default-
tables yes|no
<port list>
rmon set ports
|allports
249
Advertisement
Table of Contents
