Table of Contents
Advertisement
Chapter 5: VRRP Configuration Guide
The following table shows the priorities for each virtual router configured on Router R1:
Virtual Router
– IP address=10.0.0.1/16
VRID=1
– IP address=10.0.0.2/16
VRID=2
– IP address=10.0.0.3/16
VRID=3
Configuration of Router R2
The following is the configuration file for Router R2 in
1: interface create ip test address-netmask 10.0.0.2/16 port et.1.1
!
2: ip-redundancy create vrrp 1 interface test
3: ip-redundancy create vrrp 2 interface test
4: ip-redundancy create vrrp 3 interface test
!
5: ip-redundancy associate vrrp 1 interface test address 10.0.0.1/16
6: ip-redundancy associate vrrp 2 interface test address 10.0.0.2/16
7: ip-redundancy associate vrrp 3 interface test address 10.0.0.3/16
!
8: ip-redundancy set vrrp 1 interface test priority 200
9: ip-redundancy set vrrp 3 interface test priority 100
!
10: ip-redundancy start vrrp 1 interface test
11: ip-redundancy start vrrp 2 interface test
12: ip-redundancy start vrrp 3 interface test
Line 8 sets the Backup priority for virtual router
higher than Router R3's Backup priority for virtual router
primary Backup and Router R3 is the secondary Backup for virtual router
On line 9, the Backup priority for virtual router
Backup priority for this virtual router is 200, Router R1 is the primary Backup and Router
R2 is the secondary Backup for virtual router
70
Default Priority
255 (address owner)
100
100
Figure
6:
to 200. Since this number is
VRID=1
VRID=1
is set to 100. Since Router R1's
VRID=3
.
VRID=3
Internet Appliance User Reference Manual
Configured Priority
255 (address owner)
200 (see line 8)
200 (see line 9)
, Router R2 is the
.
VRID=1
Advertisement
Table of Contents
