Creating Rmon Cli Filters; Using Rmon Cli Filters - Cabletron Systems IA1100 User's Reference Manual

The following shows the same rmon show hosts command with a filter applied so that
only hosts with inpkts greater than 500 are displayed:
ia# rmon apply cli-filter 4
ia# rmon show hosts et.5.4
RMON I Host Table
Filter: inpkts > 500
Address
-------
00001D:9D8138 et.5.4
01000C:CCCCCC et.5.4
0180C2:000000 et.5.4
080020:835CAA et.5.4
FFFFFF:FFFFFF et.5.4
RMON CLI filters can only be used with the following groups:
• Hosts
• Matrix
• Protocol Distribution
• Application Layer Host
• Network Layer Host
• Application Layer Matrix
• Network Layer Matrix

Creating RMON CLI Filters

To create RMON CLI filters, use the following CLI command in Configure mode:
Creates an RMON CLI filter.

Using RMON CLI Filters

To see and use RMON CLI filters, use the following CLI command in User or Enable
mode:
Displays RMON CLI filters.
Applies a CLI filter on current
Telnet or Console session.
Clears the currently-selected
CLI filter.
Internet Appliance User Reference Manual
Port InPkts
---- ------
1204
2389
1540
940
1372
rmon set cli-filter
rmon show cli-filters
rmon apply cli-filters
rmon clear cli-filter
Chapter 17: RMON Configuration Guide
InOctets OutPkts
-------- -------
80110 941
740514 0
98560 0
121061 1204
285105 0
<filter-id> <parameter>
OutOctets Bcst Mcst
--------- ---- ----
121129 0
0 0
0 0
80110 0
0
<filter-id>
0
0
0
0
259