Table of Contents
Advertisement
Setting an IP QoS Policy
To set a QoS policy on an IP traffic flow, enter the following command in Configure mode:
Set an IP QoS policy.
For example, the following command assigns control priority to any traffic coming from
the 10.10.11.0 network:
ia(config)# qos set ip xyz control 10.10.11.0/24
Specifying Precedence for an IP QoS Policy
To specify the precedence for an IP QoS policy, enter the following command in Configure
mode:
Specify precedence for an
IP QoS policy.
Configuring IA Queueing Policy
The IA queuing policy is set on a system-wide basis. The IA default queuing policy is
strict priority. To change the queuing policy to weighted-fair queuing on the IA, enter the
following command in Configure mode:
Set queuing policy to
weighted-fair.
If you want to revert the IA queuing policy from weighted-fair to strict priority (default),
enter the following command in Configure mode:
Revert the IA queuing policy
to strict priority.
Internet Appliance User Reference Manual
<name> <priority> <srcaddr/mask>
qos set ip
<dstaddr/mask>
|any
<tos>
<port list>
|any
<protocol>
<tos-mask>|
|any
rewrite>|
<tos-rewrite>|
any
qos precedence ip [sip
[srcport
<num>
[tos
<num>
]
qos set queuing-policy weighted-fair port
<port list>
|all-ports
<line within active-configuration containing qos
negate
set queuing-policy weighted-fair>
Chapter 15: QoS Configuration Guide
<srcport>
<dstport>
|any
<interface-list>
|
|any
<tos-precedence-
any
any
<num>
] [dip
<num>
<num>
] [destport
<num>
] [protocol
|any
|any
<num>
]
]
] [intf
237
Advertisement
Table of Contents
