Redistributing Directly Attached Networks; Redistributing Rip Into Rip; Redistributing Rip Into Ospf - Cabletron Systems IA1100 User's Reference Manual

Redistributing Directly Attached Networks

Routes to directly attached networks are redistributed to another routing protocol such as
RIP or OSPF by the following command. The network parameter specifies a set of routes
that will be redistributed by this command. If all direct routes are to be redistributed set
the network parameter to all. Note that the network parameter is a filter that is used to
specify routes that are to be redistributed.
To redistribute direct routes, enter one of the following commands in Configure mode:
To redistribute direct routes
into RIP.
To redistribute direct routes
into OSPF.

Redistributing RIP into RIP

The IA routing process requires RIP redistribution into RIP if a protocol is redistributed
into RIP.
To redistribute RIP into RIP, enter the following command in Configure mode:
To redistribute RIP into RIP.

Redistributing RIP into OSPF

RIP routes may be redistributed to OSPF.
To redistribute RIP into OSPF, enter the following command in Configure mode:
To redistribute RIP into OSPF.
Internet Appliance User Reference Manual
Chapter 9: Routing Policy Configuration Guide
ip-router policy redistribute from-proto
direct to-proto rip network all
ip-router policy redistribute from-proto
direct to-proto ospf network all
ip-router policy redistribute from-proto rip
to-proto rip
ip-router policy redistribute from-proto rip
to-proto ospf
143