Configuring Ospf Interface Parameters - Cabletron Systems IA1100 User's Reference Manual

Configuring OSPF Interface Parameters

You can configure the OSPF interface parameters shown in
Table 1. OSPF Interface Parameters
OSPF Parameter
Interface OSPF State (Enable/Disable)
Cost
No multicast
Retransmit interval
Transit delay
Priority
Hello interval
Router dead interval
Poll Interval
Key chain
Authentication Method
To configure OSPF interface parameters, enter one of the following commands in
Configure mode:
Enable OSPF state on interface.
Specify the cost of sending a packet
on an OSPF interface.
Specify the priority for determining
the designated router on an OSPF
interface.
Specify the interval between OSPF
hello packets on an OSPF interface.
Configure the retransmission interval
between link state advertisements for
adjacencies belonging to an OSPF
interface.
Internet Appliance User Reference Manual
Chapter 7: OSPF Configuration Guide
Table
Default Value
Enable (except for virtual links)
1
Default is using multicast mechanism
5 seconds
1 second
0
10 seconds (broadcast), 30 (non broadcast)
4 times the hello interval
120 seconds
N/A
None
ospf set interface
state disable|enable
ospf set interface
cost <num>
ospf set interface
<num>
priority
ospf set interface
hello-interval
ospf set interface
retransmit-interval
1.
<name-or-IPaddr>
|all
<name-or-IPaddr>
|all
<name-or-IPaddr>
|all
<name-or-IPaddr>
|all
<num>
<name-or-IPaddr>
|all
<num>
85