Table of Contents
Advertisement
The following table shows the priorities for each virtual router configured on Router R2:
Virtual Router
– IP address=10.0.0.1/16
VRID=1
– IP address=10.0.0.2/16
VRID=2
– IP address=10.0.0.3/16
VRID=3
Note:
Since 100 is the default priority, line 9, which sets the priority to 100, is actually
unnecessary. It is included for illustration purposes only.
Configuration of Router R3
The following is the configuration file for Router R3 in
1: interface create ip test address-netmask 10.0.0.3/16 port et.1.1
!
2: ip-redundancy create vrrp 1 interface test
3: ip-redundancy create vrrp 2 interface test
4: ip-redundancy create vrrp 3 interface test
!
5: ip-redundancy associate vrrp 1 interface test address 10.0.0.1/16
6: ip-redundancy associate vrrp 2 interface test address 10.0.0.2/16
7: ip-redundancy associate vrrp 3 interface test address 10.0.0.3/16
!
8: ip-redundancy set vrrp 1 interface test priority 100
9: ip-redundancy set vrrp 2 interface test priority 100
!
10: ip-redundancy start vrrp 1 interface test
11: ip-redundancy start vrrp 2 interface test
12: ip-redundancy start vrrp 3 interface test
Lines 8 and 9 set the Backup priority for Router R3 at 100 for virtual routers
. Since Router R1 has a priority of 200 for backing up virtual router
VRID=2
Router R2 has a priority of 200 for backing up virtual router
secondary Backup for both virtual routers
Internet Appliance User Reference Manual
Chapter 5: VRRP Configuration Guide
Default Priority
100
255 (address owner)
100
Figure
6:
VRID=1
and
.
VRID=1
VRID=2
Configured Priority
200 (see line 8)
255 (address owner)
100 (see line 9)
and
VRID=1
, and
VRID=2
, Router R3 is the
71
Advertisement
Table of Contents
