Table of Contents
Advertisement
Chapter 6: RIP Configuration Guide
Configuring RIP
By default, RIP is disabled on the IA and on each of the attached interfaces. To configure
RIP on the IA, follow these steps:
1.
Start the RIP process by entering the rip start command.
2.
Use the rip add interface command to inform RIP about the attached interfaces.
Enabling and Disabling RIP
To enable or disable RIP, enter one of the following commands in Configure mode:
Enable RIP.
Disable RIP.
Configuring RIP Interfaces
To configure RIP in the IA, you must first add interfaces to inform RIP about attached
interfaces.
To add RIP interfaces, enter the following commands in Configure mode:
Add interfaces to the RIP
process.
Add gateways from which
the IA will accept RIP
updates.
Define the list of routers to
which RIP sends packets
directly, not through
multicast or broadcast.
78
rip start
rip stop
<interfacename-or-IPaddr>
rip add interface
rip add trusted-gateway
rip add source-gateway
Internet Appliance User Reference Manual
<interfacename-or-IPaddr>
<interfacename-or-IPaddr>
Advertisement
Table of Contents
