Table of Contents
Advertisement
Chapter 7: OSPF Configuration Guide
3.
Create a Static export source since we would like to export static routes.
ip-router policy create static-export-source statExpSrc
4.
Create a Direct export source since we would like to export interface/direct routes.
ip-router policy create direct-export-source directExpSrc
5.
Create the Export-Policy for redistributing all interface routes and static routes into
OSPF.
ip-router policy export destination ospfExpDstType1 source
ip-router policy export destination ospfExpDstType2 source
Exporting All RIP, Interface, and Static Routes to OSPF
Note:
Also export interface, static, RIP, OSPF, and OSPF-ASE routes into RIP.
In the configuration shown in
interfaces of routers R1 and R2 on network 120.190.0.0/16.
We would like to redistribute these RIP routes as OSPF type-2 routes and associate the tag
100 with them. Router R1 would also like to redistribute its static routes as type-2 OSPF
routes. The interface routes would redistributed as type-1 OSPF routes.
Router R1 would like to redistribute its OSPF, OSPF-ASE, RIP, Static, and Interface/Direct
routes into RIP.
1.
Enable RIP on interface 120.190.1.1/16.
rip add interface 120.190.1.1
rip set interface 120.190.1.1 version 2 type multicast
2.
Create a OSPF export destination for type-1 routes.
ip-router policy create ospf-export-destination ospfExpDstType1
3.
Create a OSPF export destination for type-2 routes.
ip-router policy create ospf-export-destination ospfExpDstType2
92
directExpSrc network all
statExpSrc network all
Figure 7 on page
type 1 metric 1
type 2 metric 4
95, RIP Version 2 is configured on the
Internet Appliance User Reference Manual
Advertisement
Table of Contents
