Table of Contents
Advertisement
Enable Mode
Enable mode provides more facilities than User mode. You can display critical features
within Enable mode including router configuration, access control lists, and SNMP
statistics. To enter Enable mode from the User mode, enter the command enable (or en),
and then supply the password when prompted.
The Enable mode command prompt consists of the ia name followed by the pound
sign (#):
ia#
To exit Enable mode and return to User mode, either type exit and press Return or press
Ctrl+Z.
Configure Mode
Configure mode provides the capabilities to configure all features and functions on the IA.
These include router configuration, access control lists, and spanning tree. To enter
Configure mode, enter the command config from Enable mode.
Note:
As mentioned previously, up to four Telnet sessions can be run simultaneously on
the IA. All four sessions can be in Configure mode at the same time, so you
should consider limiting access to the IA to authorized users.
The Configure mode command prompt consists of the ia name followed by (config) and a
pound sign (#):
ia(config)#
To exit Configure mode and return to Enable mode, either type exit and press Return or
press Ctrl+Z.
Boot PROM Mode
If your IA does not find a valid system image on the external PCMCIA flash, the system
might enter programmable read-only memory (PROM) mode. You should then reboot the
IA (enter the command reboot at the boot PROM prompt) to restart the system. If the
system fails to reboot successfully, call Cabletron Systems, Inc., Technical Support to
resolve the problem.
For information on how to upgrade the boot PROM software and boot using the
upgraded image, see the Internet Appliance 1100/1200 Getting Started Guide.
Internet Appliance User Reference Manual
Chapter 1: Introduction
27
Advertisement
Table of Contents
