Table of Contents
Advertisement
Chapter 5: VRRP Configuration Guide
Monitoring VRRP
The IA provides two commands for monitoring a VRRP configuration: ip-redundancy
trace, which displays messages when VRRP events occur, and ip-redundancy show,
which reports statistics about virtual routers.
ip-redundancy trace
The ip-redundancy trace command is used for troubleshooting purposes. This command
causes messages to be displayed when certain VRRP events occur on the IA. To trace
VRRP events, enter the following commands in Enable mode:
Display a message when any
VRRP event occurs. (Disabled
by default.)
Display a message when a
VRRP router changes from one
state to another; for example
Backup to Master. (Enabled by
default.)
Display a message when a
VRRP packet error is detected.
(Enabled by default.)
Enable all VRRP tracing.
ip-redundancy show
The ip-redundancy show command reports information about a VRRP configuration. To
display VRRP information, enter the following commands in Enable mode:
Display information about all
virtual routers.
Display information about all
virtual routers on a specified
interface.
Display detailed statistics about
a specific virtual router
74
ip-redundancy trace vrrp events enabled
ip-redundancy trace vrrp state-transitions
enabled
ip-redundancy trace vrrp packet-errors
enabled
ip-redundancy trace vrrp all enabled
ip-redundancy show vrrp
ip-redundancy show vrrp interface
ip-redundancy show vrrp
<interface>
verbose
Internet Appliance User Reference Manual
<interface>
<vrid>
interface
Advertisement
Table of Contents
