Table of Contents
Advertisement
Chapter 17: RMON Configuration Guide
Troubleshooting RMON
If you are not seeing the information you expected with an rmon show command, or if the
network management station is not collecting the desired statistics, first check that the
port is up. Then, use the rmon show status command to check the RMON configuration
on the IA.
Check the following fields on the rmon show status command output:
ia# rmon show status
RMON Status
-----------
* RMON is ENABLED
1
* RMON initialization successful.
2
+--------------------------+
| RMON Group Status
+-------+--------+---------+
| Group | Status | Default |
+-------+--------+---------+
| Lite
|
On |
+-------+--------+---------+
| Std
|
On |
+-------+--------+---------+
| Pro
|
On |
+-------+--------+---------+
RMON is enabled on: et.5.1, et.5.2, et.5.3, et.5.4, et.5.5, et.5.6, et.5.7, et.5.8
RMON Memory Utilization
-----------------------
Total Bytes Available:
Total Bytes Allocated to RMON:
Total Bytes Used:
Total Bytes Free:
1.
Make sure that RMON has been enabled on the IA. When the IA is booted, RMON is
off by default. RMON is enabled with the rmon enable command.
2.
Make sure that at least one of the RMON support levels—Lite, Standard, or
Professional—is turned on with the rmon set lite|standard|professional command.
3.
Make sure that RMON is enabled on the port for which you want statistics. Use the
rmon set ports command to specify the port on which RMON will be enabled.
260
|
Yes |
4
Yes |
Yes |
48530436
4000000
2637872
1362128
5
Internet Appliance User Reference Manual
3
Advertisement
Table of Contents
