Adding Or Modifying Frame Relay Bridge Ports; Conþguring Lan Bridge Ports - Cabletron Systems SPECTRUM 1800 User Manual

Blocked Flag
This value will cause the port to be enabled (if No) or disabled (if Yes) when the
device is powered up or rebooted. Whichever state is selected, the port will
remain in that state until this value is changed or until an enable or disable action
is performed. The default value for this parameter is No.

Adding or Modifying Frame Relay Bridge Ports

First, access the Bridge/LLC2 Frame Relay Interface Table (see
Frame Relay Bridge
To add a new Frame Relay bridge port:
1. Enter the RLP, Port, and DLCI numbers, and the other configurable values for
2. Click on
To modify an existing entry:
1. In the list box, click to select the Frame Relay Interface you wish to modify.
2. Edit the fields, as desired. If you make some changes, and would like to return
3. Click on
To delete an existing entry:
1. In the list box, click to select the Frame Relay Interface you wish to delete. The
2. Click on
After you have made system-level changes (such as conÞguring a Bridge Interface), you
must apply those changes by rebooting the FRX or SmartSwitch 1800 device, or through
NOTE
console management via the [F7] command.
Configuring LAN Bridge Ports
You can use the Bridge/LLC2 LAN Interface Table to conÞgure a LAN interface to
operate as a bridge connection to the local LAN. To access the table:
1. Click on
Configuring Bridge Ports
Ports,
each bridge port.
to add your new entry.
The selected entry will be highlighted. (Note that you can only modify one
entry at a time.)
to the original values, click on the Refresh button.
to modify the selected entry.
selected entry will be highlighted. (Note that you can only delete one entry at
a time.)
to delete the selected entry.
to display the Device menu.
page 11-4).
Bridge Configuration
ConÞguring
11-7