Cabletron Systems SPECTRUM 1800 User Manual page 55

SABM/DISC with wrong link address
The HDLC frame processor task for the port has received an improperly
addressed frame from the subscriber. This situation usually occurs when the port
and subscriber devices are both conÞgured as logical DCEs or logical DTEs.
Severity
Action
Illegal TC/Gen Clk Combination
The software has determined that a port is set to run at an illegal line speed
(throughput class).
Severity
Action
Excessively noisy line
Self-explanatory.
Severity
Action
LP Buf Usage exceeded T: "n" C: "n"
The RLP statistic Percentage of Buffers in Use has exceeded the threshold
(T: ÒnÓ) that was set by the user. (C: ÒnÓ is the current value.)
Severity
Action
LP Msg Queued exceeded T: "n" C: "n"
The RLP statistic Number of Queued Messages has exceeded the threshold
(T: ÒnÓ) that was set by the user. (C: ÒnÓ is the current value.)
Severity
Action
LP Rcv Frm/Sec exceeded T: "n" C: "n"
The RLP statistic Received Frames/Sec has exceeded the threshold (T: ÒnÓ) that
was set by the user. (C: ÒnÓ is the current value.)
Severity
Action
Trap Messages
Informational (Level 4)
Modify the Port record so that one end of the connection is a
logical DCE and the other is a logical DTE.
Critical (Level 1)
This is probably a conÞguration error. Check the Port record and
change the throughput class, if necessary.
Minor (Level 3)
Check the communications line and cables.
Informational (Level 4)
If this happens frequently, you may need to reroute some trafÞc.
Informational (Level 4)
If this happens frequently, you may need to reroute some trafÞc.
Informational (Level 4)
If this happens frequently, you may need to reroute some trafÞc.
Configuring the Trap Table
198
219
250
304
305
306
3-5