Cabletron Systems SPECTRUM 1800 User Manual page 97

The Frame Relay DLCI Table window allows you to conÞgure the following
parameters for each DLCI:
In the DLCI Table you can conÞgure Primary and Backup DLCIs. If you are conÞguring
a primary DLCI, there are six additional parameters that can only be conÞgured through
NOTE
console management. They are: Remote RLP, Remote Port, Remote DLCI, Switchover
Timer, Switchback Timer, and Time to Hold Data While Waiting. For information on
conÞguring these parameters, refer to your FRX or SmartSwitch 1800 hardware
documentation.
DLCI
Use this Þeld to enter the identiÞer (16 - 991) for the DLCI whose trafÞc
parameters you wish to conÞgure. These DLCI numbers are typically assigned by
your frame relay service provider.
CIR (In/Out)
Use this Þeld to enter the Committed Information Rate (CIR) assigned to the
selected DLCI by your frame relay provider. This value deÞnes the amount of
data guaranteed to be transmitted over the carrierÕs network. Any burst of data
Configuring Frame Relay Ports
Figure 5-2. Frame Relay DLCI Table
Frame Relay Status and Configuration
5-9