Cabletron Systems SPECTRUM 1800 User Manual page 24

Using the FRX4000, FRX6000, and SmartSwitch 1800 Hub View
IP Address
The deviceÕs Internet Protocol address; this Þeld will display the IP address you
have used to create the device icon (if you are running the Hub View from a
management platform) or the IP address you used to launch the Hub View
program (if you are running in stand-alone mode). You cannot change the IP
address from within SPMA.
For FRX Þrmware versions 3.3.0, 3.3.1, and 4.0, each installed LAN card can be assigned
an IP address. The IP address you use to communicate with the FRX devices via SNMP is
TIP
an IP address which has been assigned to a LAN card interface. For FRX6000s which have
two LAN cards installed, each can be assigned its own IP address, if desired; either of these
IP addresses can be used for SNMP communication.
For FRX6000s which do not have a LAN card installed, an IP address can be assigned to
any Frame Relay port which is also running the IP protocol; in this case, you would use
this IP address to communicate with the device via SNMP and SPMA.
2-8 Using the Hub View