BSCI: Invalid queue operations
An invalid operation has occurred and has disabled the port.
Severity
Action
BSCI: Invalid protocol operations
An invalid operation has occurred and has disabled the port.
Severity
Action
BSCI: Invalid CUA, DUA operations
An invalid operation has occurred and has disabled the port.
Severity
Action
Invalid Line Speed LP "n" Port "n"
Self-explanatory.
Severity
Action
I-FRM Blocked-Remote Busy Timeout
An RNR (Receive Not Ready) condition on the port has been cleared by
expiration of the Remote Busy Timer, which caused the port to be reset.
Severity
Action
I-FRM Blocked-No Acks from Remote
The remote user device is not accepting transmission from the local device, and
the local port has been reset.
Severity
Action
Enter Service Affecting Condition
The DTE and DCE exchange messages regularly so that each knows the other is
running and ready. If one end does not respond, this event message is sent and
the link goes down.
Severity
Action
Trap Messages
Minor (Level 3)
Take the same action as for message 500.
Minor (Level 3)
Take the same action as for message 500.
Minor (Level 3)
Take the same action as for message 500.
Minor (Level 3)
Correct the line speed in the Port record.
Major (Level 2)
Check the user device for a problem that caused the RNR.
Major (Level 2)
Check the remote device for a problem.
Major (Level 2)
Check the equipment to see what caused the failure to respond.
Configuring the Trap Table
521
522
523
524
530
531
532
3-21