Table of Contents
Advertisement
Heat input calculation in weld history view
The heat input of a weld can be calculated by entering the weld length into the weld's history entry.
1.
Select 'Set length' by pressing the right control knob button.
2.
Set the weld length by turning the right control knob.
3.
Confirm the weld length for calculation by pressing the control knob button.
3.3.4 Auto control panel: Welding parameters
The Welding parameters view includes a start and stop curve for adjusting the most essential parameters for a weld. The
bottom section of the view lists the available adjustments for the selected welding process. The welding process selec-
tion is based on the active memory channel and its settings.
Many of the welding parameters are welding process specific and are visible and available for adjustment accord-
ingly.
© Kemppi
84
X5 FastMig
Operating manual - EN
1920960 / 2144
Advertisement
Table of Contents
