Table of Contents
Advertisement
4.1 Daily maintenance
Disconnect the power source from the mains before handling electrical cables.
Maintenance of power source and wire feeder
Follow these maintenance procedures to maintain the proper functioning of the welding system:
•
Check that all covers and components are intact.
•
Check all the cables and connectors. Do not use them if they are damaged and contact service for replacements.
•
Check the wire feeder's feed rolls and the pressure handle. Clean and lubricate with a small quantity of light
machine oil if needed.
For repairs, contact Kemppi at
Welding gun maintenance
For Flexlite GX MIG gun instructions, refer to userdoc.kemppi.com.
© Kemppi
www.kemppi.com
or your dealer.
102
X5 FastMig
Operating manual - EN
1920960 / 2144
Advertisement
Table of Contents
