Kemppi X5 FastMig Operating Manual page 78

MMA settings
The parameters listed here are available for adjustment with the MMA process.
Parameter
Hot start
VRD
Current limit min
Current limit max
Common settings
The parameters listed here are common system settings.
Parameter
Weld data
Display off
Date
Time
Time counter total
Time counter since
© Kemppi
Parameter value
Min/Max = -30 ... +30, step 1
Default = 0
OFF/12V/24V
Default = OFF
Min/Max = 10 ... machine size A, step 1
Default = 10 A
Min/Max = 10 ... machine size A, step 1
Default = 10 A
Parameter value
Min/Max = 0 ... 10 s, step 1
0 = OFF
Default = 5 s
Min/Max = 5 ... 120 min, step 1
Default = 5 min
Current date
Current time
>>>
>>>
78
Operating manual - EN
Description
Welding function that uses higher or
lower welding current at the start of the
weld. During the Hot start period the cur-
rent changes to the normal welding cur-
rent level. The Hot start value affects the
current level and duration. Use it to pre-
vent the electrode from sticking to the
work piece.
Voltage reduction device (VRD) reduces
the open-circuit voltage to maintain
below a certain voltage value.
Minimum and maximum limits for the
current adjustment.
Description
This defines how long the weld data sum-
mary is shown after each weld.
Not available with MMA or gouging.
Adjusting date:
Select day by pressing the knob key
Adjust day by rotating the knob
(Min/Max = 1...28/29/30/31)
Select month by pressing the knob key
Adjust month by rotating the knob
(Min/Max = 1...12)
Select year by pressing the knob key
Adjust year by rotating the knob
(Min/Max = 2000...2099)
Press the knob key to end adjustment.
Adjusting time:
Select hours by pressing the knob key
Adjust hours by rotating the knob
(Min/Max = 0...23)
Select minutes by pressing the knob key
Adjust minutes by rotating the knob
(Min/Max = 0...59)
Press the knob key to end adjustment.
This shows the total arc time and power
on time.
This shows the total arc time and power
on time since the last reset.
X5 FastMig
1920960 / 2144