Table of Contents
Advertisement
(Fc, Mc, Ss, Fe)
(The materials mentioned inside brackets refer to secondary suitability.)
8.
Follow the previous steps in reverse to install the wire feed rolls. Align the cut on the drive rolls' bottom with the pin
on the drive shaft.
9.
Reattach the mounting caps and mounting pins to lock the drive and pressure rolls into their places.
10.
Close the locking arms and lower the pressure handles on the feed rolls. Refer to "Installing and changing wire (X5
WF 300)" on page 53 and "Installing and changing wire (X5 WF 200)" on page 48 for more information on the wire
installation.
11.
Close the wire feeder cabinet.
© Kemppi
U-groove
1.0
1.2
1.6
W006088
W006090
W006092
62
X5 FastMig
Operating manual - EN
W006089
W006091
W006093
1920960 / 2144
Advertisement
Table of Contents
