Table of Contents
Advertisement
3.3.7 Auto control panel: System settings
Changing settings
1.
Turn the right control knob to highlight the desired settings parameter.
2.
Press the right control knob to select the settings parameter for adjustment.
3.
Turn the right control knob to select the settings value.
>> Depending on the settings parameter to be adjusted, refer also to the Settings table below for more details.
4.
Confirm the new value / selection and close the adjustment view by pressing the right control knob.
Users
The system settings can be customized for up to 10 different users. In addition to the system settings, the memory chan-
nels are user-specific. Each user can have up to 100 MIG channels, 10 TIG channels, 10 MMA channels and 10 gouging
channels. The memory channel and system settings are saved automatically for the logged-in user.
Settings
Parameter
User
Operation mode
Remote control
Remote mode
(with 1-knob remote control)
© Kemppi
Parameter value
Current user
MIG/TIG/MMA/Gouging
OFF/Remote/Gun
Default = OFF
Wire feed speed / Channel
90
Operating manual - EN
Description
There is always a logged-in user in the sys-
tem. When a new user logs in, the pre-
vious user is automatically logged out.
In case of a mixed double wire feeder
installation (Manual+Auto), user 1 is auto-
matically applied and user change is dis-
abled.
If remote controller is not connected, this
selection is not available.
This determines what is changed with
the remote, parameter or memory chan-
nel (available channels: 1...5). If remote
controller is not connected and remote
not selected, this selection is not avail-
able.
X5 FastMig
1920960 / 2144
Advertisement
Table of Contents
