Kemppi X5 FastMig Operating Manual page 52

8. Press the wire inch button to drive the filler wire into the welding gun. Stop when the wire reaches the welding
gun's contact tip.
>> In X5 Wire Feeder 200 the wire inch button is located in the control panel.
Watch out for the wire when it reaches the contact tip and exits the gun.
9. Before welding, ensure that the welding parameters and settings on the control panel conform to your welding
setup.
>> Refer to "Using X5 Manual control panel" on page 74 and "Using X5 Auto control panel" on page 80 for more
information.
"Wire spool and hub (200)" on page 11
© Kemppi
52
X5 FastMig
Operating manual - EN
1920960 / 2144