Table of Contents
Advertisement
Adjusting welding parameters
1.
Turn the right control knob to highlight the desired welding parameter.
2.
Press the right control knob to select the welding parameter for adjustment.
3.
Turn the right control knob to adjust welding parameter value.
>> Depending on the parameter to be adjusted, refer also to the Welding parameters table below for more details.
4.
Confirm the new value / selection and close the adjustment view by pressing the right control knob.
Saving welding parameters for later use
A work channel is automatically created for the changed welding parameters. To save the set welding parameters on a
memory channel, do one of the following:
•
Quick active channel option: Keep the Channels shortcut button pressed for approximately 2 seconds.
>> This will save the parameter settings onto the currently active channel replacing its previous parameter set-
tings.
•
Channels view option: Go to the Channels view and save the parameter settings onto a new channel.
>> Refer to "Auto control panel: Memory channels" on page 82 for more information.
Welding parameters and feature descriptions
MIG and 1-MIG welding parameters
The parameters listed here are available for adjustment with the MIG and 1-MIG processes.
Parameter
Trigger logic
Touch Sense Ignition
Post current
Dynamics
WF end step
© Kemppi
Parameter value
2T, 4T
OFF/ON
-30 ... +30
-10.0 ... +10.0, step 0.2
Default = 0
OFF/ON
Default = OFF
85
Operating manual - EN
Description
Welding guns can have several altern-
ative trigger operation modes (trigger
logics). Most common are 2T and 4T. In
2T mode you hold the trigger down
while welding. In 4T mode you press and
release the trigger to start or to stop weld-
ing.
Touch Sense Ignition delivers minimum
spatter and stabilizes the arc immediately
after ignition.
Post current setting affects the wire
length at the weld end, for example to
prevent the wire from stopping too close
to the weld pool. This also enables the
optimum wire length for the start of the
next weld.
Controls the short circuit behavior of the
arc. The lower the value the softer the arc,
the higher the value the rougher the arc.
Wire feed end step feature prevents the
filler wire from sticking to the work piece
when the welding ends. This is accom-
plished by pulling the wire back briefly.
X5 FastMig
1920960 / 2144
Advertisement
Table of Contents
