Gear Stage Of The Reduction Gearing: Test/Set - AUMA SAV 07.2 Operation Instructions Manual

Commissioning (settings/options in the actuator)
11.2.2.

Gear stage of the reduction gearing: test/set

70
SAV 07.2 SAV 16.2 / SARV 07.2
4. Check settings:
The setting of the mechanical position indicator is correct if the angle between
the symbols (OPEN) and
280°.
If all three discs are turned at the same time, the indicator can be shifted in
steps of 15°. Individual shifts of 5° are possible.
If the indicator is rotated too far (more than 280°) or if the angle is too small
(below 120°), adapt the gear stage setting to the actuator turns/stroke. Refer
to <Gear stage of the reduction gearing: test/set>.
The test/setting is only required if the mechanical position indicator cannot be correctly
set.
1. Refer to table and check if turns/stroke correspond to the setting of the reduction
gearing (stages 1 9).
Table 25:
Turns of actuator per valve stroke and suitable reduction gearing setting
for 1 500 turns/stroke
[exceeding to]
1.0 1.9
1.9 3.7
3.7 7.9
7.9 15.0
15.0 31.5
31.5 60.0
60.0 126
126 240
240 500
2. To modify settings, lift the lever at the reduction gearing and engage at the se-
lected stage.
Figure 78: Set reduction gearing
SARV 16.2 Control unit: electronic (MWG)
(CLOSED) ranges between approx. 120° and
for 10 5,000 turns/stroke
[exceeding to]
10 19
19 37
37 79
79 150
150 315
315 600
600 1,260
1,260 2,400
2,400 5,000
ACV 01.2 HART
Reduction gearing
Stage
1
2
3
4
5
6
7
8
9