Mechanical Position Indication Via Indicator Mark (Not Self-Adjusting); Mechanical Position Indicator: Set; Gear Stage Of The Reduction Gearing: Test/Set - AUMA SAV 07.2 Operation Instructions Manual

SAV 07.2 SAV 16.2 / SARV 07.2
ACV 01.2 HART
11.3.

Mechanical position indication via indicator mark (not self-adjusting)

Setting elements
11.3.1.

Mechanical position indicator: set

11.3.2.

Gear stage of the reduction gearing: test/set

Information
SARV 16.2 Control unit: electronic (MWG)
Figure 79: Mechanical position indication via indicator mark
The mechanical position indicator shows the valve position via two indicator discs
with symbols (OPEN) and
OPEN/CLOSED point to the indicator mark
The position indications is housed in the actuator switch compartment. The switch
compartment must be opened to perform any settings. Refer to <Switch compartment:
open/close>.
1. Move valve to end position CLOSED.
2.
Turn lower indicator disc until symbol
mark on the cover.
3. Move actuator to end position OPEN.
4.
Hold lower indicator disc in position and turn upper disc with symbol
until it is in alignment with the
5. Move valve to end position CLOSED again.
6. Check settings:
If the symbol (CLOSED) is no longer in alignment with
6.1 Repeat setting procedure.
6.2 Test/set gear stage of the reduction gearing.
This test/setting is only required if the turns/stroke of the actuator were changed at
a later date. The control unit may possibly have to be exchanged:
The adjustable stroke range is indicated on the order data sheet (e.g. "1
turns/stroke").
Commissioning (settings/options in the actuator)
(CLOSED). When correctly set, the symbols
at the cover in the end positions.
(CLOSED) is in alignment with the
mark on the cover.
(OPEN)
mark on the cover:
500
71